1. Manuals
  2. Brands
  3. Paragon Manuals
  4. Indoor Fireplace
  5. FOCUS HE SLIMLINE SC
  6. Owner's manual

Paragon FOCUS HE SLIMLINE SC Owner's Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
FOCUS HE SLIMLINE SC
OWNER'S
MANUAL
Please read these instructions carefully before you start
using the appliance
Keep this booklet handy for future reference
This appliance is
for use in Great Britain or
IRELAND only
This appliance is
for use in GREAT BRITAIN or IRELAND only
A QUALITY PRODUCT FROM PARAGON FIRES

Advertisement

Table of Contents
loading

Related Manuals for Paragon FOCUS HE SLIMLINE SC

Summary of Contents for Paragon FOCUS HE SLIMLINE SC

  • Page 1 Please read these instructions carefully before you start using the appliance Keep this booklet handy for future reference This appliance is for use in Great Britain or IRELAND only This appliance is for use in GREAT BRITAIN or IRELAND only A QUALITY PRODUCT FROM PARAGON FIRES...
  • Page 2 FOCUS HE SLIMLINE SC Instructions CONTENTS PAGE USERS INSTRUCTIONS SECTION ONE Introduction SECTION TWO Operating Appliance SECTION THREE Fuel Bed Cleaning and Layout SECTION FOUR Cleaning SECTION FIVE General Points INSTALLATION INSTRUCTIONS SECTION SIX Appliance Data SECTION SEVEN Regulations and Warnings...

  • Page 3: Users Instructions

    „hazardous waste' and should be disposed of at a site licensed for the disposal of industrial waste.  The FOCUS HE SLIMLINE SC is a decorative fuel effect appliance with a radiant heat conserver box and glass panel for improved efficiency.

  • Page 4: Operation

    FOCUS HE SLIMLINE SC Users Instructions SECTION ONE Important Information Continued INTRODUCTION  The FOCUS HE SLIMLINE SLIDE CONTROL incorporates a single gas control, which selects ignition pilot, and main burner low and high settings.  The appliance incorporates a safety device in the form of an Oxygen Depletion System, which constantly monitors the oxygen in the room and will cause the fire to switch off if the oxygen level reduces, for instance due to insufficient ventilation or a blocked flue.

  • Page 5: Removing Glass Panel

    FOCUS HE SLIMLINE SC Users Instructions SECTION THREE Fuel Bed Cleaning and Layout Warning: - Before you clean any part of the appliance ensures that the appliance is turned off and cold. Important: - Refer to the ‘Health & Safety Notice located on page 3 of this booklet before cleaning or replacing any refractory material.
  • Page 6 FOCUS HE SLIMLINE SC Users Instructions SECTION THREE Fuel Bed Cleaning and Layout 6 OFF “A” Coal Shapes 9 OFF “B” Coal Shapes FUEL BED LAYOUT (COAL OPTION)  Ensure the REAR MATRIX is in position as shown located against the rear edge of the burner outlet.

  • Page 7: Fuel Bed Layout

    FOCUS HE SLIMLINE SC Users Instructions SECTION THREE Fuel Bed Cleaning and Layout Continued  Locate the first row of coals within the location points in the front matrix.  Lay a second layer of coals as shown.  Lay the third layer of coals so that they bridge across the first and second rows.
  • Page 8 FOCUS HE SLIMLINE SC Users Instructions SECTION THREE Fuel Bed Cleaning and Layout Continued  Locate the Front Matrix as shown.  Locate the first row of Pebbles within the location points in the front matrix.  Lay a second layer of Pebbles as shown.

  • Page 9: Cleaning: Black Painted Surfaces

    FOCUS HE SLIMLINE SC Users Instructions SECTION FOUR Cleaning CLEANING: BRASS The brass fret and brass effect fire surround trim may be cleaned with a clean damp cloth. N.B The trim and fire front should be removed for cleaning. (The trim is held in place by magnetic strips.)

  • Page 10: Cleaning: Pilot Assembly

    FOCUS HE SLIMLINE SC Users Instructions SECTION FOUR Cleaning Continued CLEANING: PILOT ASSEMBLY Pilot Cleaning (Before cleaning ensure that the appliance is turned off and cold) In some instances you may experience ignition problems even when the appliance is new. This may be due to the aeration hole in the pilot body (see photograph) being partial blocked with dust, pet hairs or other foreign matter.

  • Page 11: Installation Instructions

    FOCUS HE SLIMLINE SC Installation Instructions SECTION SIX Appliance Data Category of Appliance Category Gas Type Gas Pressure: 20 mbar 1.0mbar Gas Input (Gross) 4.2 kW (Max.) 2.40 kW (Min) Injectors: Size 290 Oxy-pilot 9044NG Data Badge Location: (Behind fret) right hand side of the appliance.

  • Page 12: Section Seven

    FOCUS HE SLIMLINE SC Installation Instructions SECTION SEVEN Regulations and Warnings Continued Health and Safety Notice Important This appliance could contain some of the materials, indicated below, that could be interpreted as being injurious to health and safety. It is the users / installers responsibility to ensure that the necessary personal protective clothing is worn when handling these materials, see below for information.
  • Page 13 FOCUS HE SLIMLINE SC Installation Instructions SECTION SEVEN Regulations and Warnings Continued  (IE) PERMANENT VENTILATION MUST COMPLY WITH THE CURRENT EDITION OF IS813.  In GB. IT IS THE LAW THAT ALL GAS APPLIANCES MUST BE INSTALLED BY A COMPETENT PERSON;...

  • Page 14: Siting The Appliance

    FOCUS HE SLIMLINE SC Installation Instructions SECTION EIGHT Siting the Appliance The fire can be installed in the following locations: - CLASS ONE & CLASS TWO & PRE-CAST A conventional brick or stone chimney as used for a solid fuel appliance with an effective cross- sectional dimension of 225 x 225 mm (9 x 9 INS) or a clay/ceramic/metal lined flue with a minimum diameter of 125mm (5 INS).

  • Page 15: Checking The Flue And Fire Opening

    FOCUS HE SLIMLINE SC Installation Instructions SECTION EIGHT Siting the Appliance continued SOFT FURNISHINGS Care should be taken to prevent any damage being caused to surrounding soft furnishings or decoration e.g. many wall coverings may become discoloured if placed too close to the appliance.

  • Page 16: Connecting The Gas Supply

    FOCUS HE SLIMLINE SC Installation Instructions SECTION NINE To Install the Appliance continued GLASS PANEL REMOVAL/REFITTING  Lift of the canopy.  Remove the glass fixing clamp secure with two wing nuts and lift it out of the retaining brackets. Take care to support the glass panel when removing the fixing clamp.

  • Page 17: Fixing Fire Into Opening

    FOCUS HE SLIMLINE SC Installation Instructions SECTION NINE To Install the Appliance continued FIXING FIRE INTO OPENING NOTE: -Remove the glass panel and put safely to one side. Do not replace until installation is completed.  Mark the position of flange holes required in the fireplace front, drill and insert wall plugs ...
  • Page 18 FOCUS HE SLIMLINE SC Installation Instructions SECTION NINE To Install the Appliance continued CONNECTING LEVER AND VALVE LINKAGE Ensure the spindle is pushed back inside the Taking great care grip the copper protective control valve as far as possible. Ensure the bell...

  • Page 19: Checking Operation Of Fire

    FOCUS HE SLIMLINE SC Installation Instructions SECTION NINE To Install the Appliance continued CONNECTING LEVER AND VALVE LINKAGE Continued Flip the slide control lever round so that the rubber-capped end is protruding out to the right as shown in the left-hand picture. Check that it slides freely up and down in the nylon slide guides.
  • Page 20 FOCUS HE SLIMLINE SC Installation Instructions SECTION TEN Checking Operation of Fire Continud CHECKING FOR COMBUSTION PRODUCTS CLEARENCE IMPORTANT:-The smoke test must be carried out with the fire starting from cold.  Light the fire and leave at maximum input.

  • Page 21: Maintenance Instructions

    FOCUS HE SLIMLINE SC Maintenance Instructions SECTION ELEVEN Maintenance GENERAL  Servicing should be carried out annually by a competent person such as a CORGI-registered person in accordance with the relevant regulations, to ensure the safe and correct operation of the appliance.

  • Page 22: Replacement Of Injector

    FOCUS HE SLIMLINE SC Maintenance Instructions SECTION ELEVEN Maintenance Continued REPLACEMENT OF INJECTOR 1. Remove burner tray (1-10 of Replacement Gas Control Tap). 2. Undo the compression nut on the supply pipe to the injector. 3. Remove the silencer pad carefully 4.
  • Page 23 7. The appliance has not been subjected to misuse or accident or been modified or repaired by any person other than the authorised employee or authorised representative of Charlton and Jenrick Ltd. 8. The registration form must be returned within 3 months of purchase. PARAGON HELPDESK NUMBER 0845 5195991 LT5316 (iss 5) 10/10...

  • Page 24: Warranty Cover

    The following information must be complete and supported by receipts as part of the conditions of the extended three year parts warranty and the appliance must be registered by completing and returning the registration document (last page of this booklet) to Paragon Fires. Date of First annual service: Engineer Name Corgi Registration No.
  • Page 25 Post Code TELEPHONE No. PRODUCT DETAILS Model: PARAGON HE FOCUS SLIMLINE Serial No. Date of Purchase This information can be found on the label attached to the packaging and on the data badge, which is located on the appliance flange, top right behind trim.
  • Page 26 LT5316 (iss 5) 10/10...
  • Page 27 LT5316 (iss 5) 10/10...
  • Page 28 Product Serial No A-0136 ID Label Prefix Fire Box Labels: Spillage (1057) Data Badge Fire Box Grommet Burner Tray / Box Assembly Warning Label (Fire Guard) Coal Set (5322) Rear Matrix (5319) Front Matrix (5320) Glass Panel Canopy Restrictor Elbow (2613) Fixing (0705) (includes 4 magnets) Seal (4904) Battery (9V) / 7mm Spanner...

Table of Contents