Acceleration And Deceleration Curves; Automatic Lid Opening Function ("Autoopen") - Sartorius Centrisart G-16 Operating Manual

6.3.2.8

Acceleration and deceleration curves

Pos: 135 /010 Universalmodule/Seiten wechsel @ 0\m od_12 021162 44312_ 0.docx @ 105 @ @ 1
Pos: 136 /100 Si gma/1 01 BA Ze ntrifugen Sartorius (Standardm odule)/060 Betrieb/Spin control L/060 -003 0-00 20-01 01 Auto matische Deckelöffnu ng - ohne Temp Sartorius @ 37\mod_1 437374 45869 3_68.do cx @ 27 2980 @ 4 @ 1

6.3.2.9

Automatic lid opening function ("AutoOpen")

Pos: 137 /010 Universalmodule/ Leerzeile @ 0 \mo d_1202 11624 4500_0.do cx @ 114 @ @ 1
Pos: 138 /100 Si gma/1 01 BA Ze ntrifugen Sartorius (Standardm odule)/060 Betrieb/Spin control L/060 -003 0-00 20-01 11 Akustisches Signal - ohne Temp Sartorius @ 37\mod_1 437374 45937 1_68.do cx @ 27 3010 @ 4 @ 1
Version 09/2015, Rev. 1.3 of 02/03/2017
Translation of the original operating manual, WZG6001-e150401
Acceleration
This function is used to select an acceleration curve. The system offers 10 fixed,
programmed acceleration curves (curves 0-9).
Brake
This function is used in order to select a curve that decelerates the centrifuge to a
standstill. Deceleration curves are inverted images of the acceleration curves and
are labelled with identical numbers. Deceleration curve no. 0 represents a brakeless
deceleration.
Fig. 16: Preselection of a curve; here: preselection of an acceleration curve
The automatic lid opening function must be activated so that the lid opens
automatically at the end of the operation.
In order to activate the automatic lid opening function:
Select the "Auto Open" symbol with the cursor and confirm the selection. The
symbol and the bar under the symbol start to flash.
Activate the function by turning the function knob. The symbol remains
displayed in a permanent manner and the bar continues to flash.
Turning the function knob further will deactivate the function. In this case, the
symbol disappears but the bar continues to flash.
Press the function knob in order to activate the desired setting. The bar remains
visible as long as the cursor is placed over the symbol.
Fig. 17: The automatic lid opening function "Auto Open" is activated
6 Using the centrifuge
35