I ) Set The Indoor Unit Address - Sanyo SPW-CR1503GDYH8 Technical Data & Service Manual

2. Optional Controller (remote controller)

( I ) Set the indoor unit address

This function is usable if the auto. address operation is not possible.
Indoor unit address can be set one by one by remote controller in such case.
NOTE
1) In case of group control, branch wiring for group control should be removed temporarily.
2) In case of remote controller – less system, remote controller should be connected with the indoor unit
temporarily.
a
Short the two terminals of DISP PIN on indoor unit PCB.
(DISP PIN : Refer to P. VI–2)
b
Press the TEST / CHK , SET and CL buttons at the same time for more than 4 seconds.
AIR FLOW
UNIT
UNIT No.
R.C.
FLAP
TIMER SET
SET CL
c
Set the CODE No. 12 to set the No. of R. C. with the
AIR FLOW
UNIT
UNIT No.
R.C.
FLAP
TIMER SET
SET CL
MODE
No.
SET TEMP.
CODE No.
FAN SPEED
SETTING
SET DATA
ON •
OFF •
TEST / CHK
841_8132
MODE
No.
SET TEMP.
CODE No.
FAN SPEED
SETTING
SET DATA
ON •
OFF •
TEST / CHK
846_8132
III - 25
Control of W-ECO MULTI SYSTEM
, (SET TEMP) button.
3
TD831077