How To Check Overlapping Of Central Address No - Sanyo SPW-CR1503GDYH8 Technical Data & Service Manual

2. Optional Controller (system controller)

How to check overlapping of central address No.

a
Press the TEST / CHK and ZONE buttons at the same time for more than 4 seconds.
SETTING and CODE No. C1 will flash.
b
Select CODE No. C3 by pressing
C3 changes from flashing to ON state and
c
If C3 changes from ON to flashing and
complete the auto. overlap checking mode by pressing the TEST / CHK button.
d
If some of GROUP No., ZONE No. and UNIT No. flash, you should try again the zone registration.
1 Select CODE No. C1 by pressing
2 Select the flashing GROUP No. with ZONE and GROUP button.
Then press the CL button and re-select the ZONE, GROUP and UNIT No.
3 Then finally, complete the auto. overlap checking mode by pressing the TEST / CHK button.
3
In case of No-registed,
number is not displayed.
, (SET TEMP) button and press the SET button.
SETTING will flash. Then auto. overlap checking will start.
SETTING changes from flashing to ON, there is no overlapping. Then finally,
, (SET TEMP) button and press the SET button.
ALL / ZONE / GR
SELECT
ZONE
ZONE
1 9
CODE
2 No.
3
UNIT No.
GROUP 4
R.C.
SETTING
6
CENTRAL
CTRL
SET CL
OFF
: Selected GROUP No.
in case of No-registed.
III - 50
Control of W-ECO MULTI SYSTEM
Registed ZONE and GROUP
No. are displayed.
MODE
SET TEMP.
No.
FAN SPEED
FLAP
ON •
•
TEST / CHK
In case of registed, UNIT No.
will be displayed.
0205_M_I
TD831077