Sanyo SPW-CR1503GDYH8 Technical Data & Service Manual page 106

2. Optional Controller (system controller)
c
Select the zone and group No. which you want to set with ZONE and
d
Set the UNIT No. (Indoor unit address) with FAN SPEED and FLAP buttons according to the zone registration
table.
e
Press the SET button.
GROUP No. turns ON and UNIT No. (Indoor unit address) changes from flashing to ON state.
UNIT No. is registered to selected ZONE No. and GROUP No..
If you make mistake, then press the CL button and re-select the ZONE, GROUP and UNIT No.
ALL / ZONE / GR
SELECT
GROUP
3
CENTRAL
SET
f Register the other UNIT No. in the same way by following the above steps c to e.
g
Finally, complete the registration by pressing the TEST / CHK button.
R.C. No. FAN SPEED button
Indoor unit No. FLAP button
ZONE
ZONE
1 9
CODE
2 No.
3
UNIT No.
4
R.C. No.
SETTING
6
7
CTRL
CL
ON •
OFF •
Control of W-ECO MULTI SYSTEM
,
MODE
SET TEMP.
FAN SPEED
FLAP
TEST / CHK
835_8132
SETTING
III - 48
(GROUP) buttons.
For example, in case of left
Zone 3, GROUP No. 7
UNIT No. (Indoor unit address) 2-8
: UNIT No. 2–8 is registered to
Zone 3–GROUP 7.
changes from flashing to OFF state.
TD831077