(J) Change The Period Of The Filter Timer - Sanyo SPW-CR1503GDYH8 Technical Data & Service Manual

2. Optional Controller (remote controller)

(J) Change the period of the filter timer

If the period of filter timer is not suitable (for example in case of dirty environment), the period can be half done
as follows:
a
Press the TEST / CHK button for more than 4 seconds.
b
In case of group control, if you want to change all units in group control collectively, proceed next step remaining
ALL displayed.
If you want to change a unit individually, select the indoor unit address (UNIT No.) with UNIT button.
3
c
Select the CODE No. 02 with
d
Change the No. from 0 to 1 with
e
Press the SET button.
CODE No. 06, SET DATA and
f
If you make mistake, press the CL button.
g
Finally, press the TEST / CHK button.
AIR FLOW
UNIT
MODE
UNIT No.
R.C. No.
FLAP
SET TEMP.
CODE No.
TIMER SET
FAN SPEED
SETTING
SET DATA
SET CL
ON •
OFF •
TEST / CHK
, (SET TEMP) button.
,
AIR FLOW
UNIT MODE
UNIT No.
R.C. No.
FLAP
SET TEMP.
CODE No.
TIMER SET
SET TEMP.
FAN SPEED
SETTING
SET DATA
SET CL
ON •
OFF •
TEST / CHK
change from flashing to ON state.
SETTING
0213_M_I
( ) button.
EX:
UNIT No. 1–6
CODE No. 02
{
X, S, T, SL type
AS, K, F, FM type
0214_M_I
III - 28
Control of W-ECO MULTI SYSTEM
2,500 hr 1,250 hr
150 hr 75 hr
TD831077