Related Manuals for iWeld TIG 160 P Digital Pulse
Summary of Contents for iWeld TIG 160 P Digital Pulse
- Page 1 CUTTING EDGE WELDING USER’S MANUAL TIG/MMA dual function IGBT inverter technology DC welding power source TIG 160 P Digital Pulse TIG 200 P Digital Pulse TIG 250 P Digital Pulse TIG 300 P Digital Pulse...
-
Page 2: Fire Hazard
WARNING! Welding and cutting is dangerous to the operator, people in or near the working area, and the surrounding, if the equipment is not correctly operated. Therefore, the perfor- mance of welding/cutting must only be under the strict and comprehensive obser- vance of all relevant safety regulations. - Page 3 AN INTRODUCTION TO DC WELDERS MAIN PARAMETERS INSTALLATION 17-18. OPERATION CAUTIONS MAINTENANCE...
- Page 4 Introduction First of all, thank you for choosing our welding equipment and uses. Welding using advanced technology and a high-frequency inverter , high power IGBT rectified current, and then by using the PWM output direct current makes it suitable for high-performance work , greatly reducing the weight and dimensions of the main transformer 30% increase in efficiency.
- Page 5 The main parameter Parameters/Modell TIG 160P TIG 200 P TIG 250 P TIG 300 P 800TIG160DIPU 800TIG200DIPU 800TIG250DIPU 800TIG300DIPU Single phase 220V ±15%; 50-60 Power voltage (V) Three phase 380V±10% 50-60 Hz Rated input power capacity (KVA) No-load voltage (V) Output current scope (A) 10-160 10-140 10-200 10-180 10-250 10-230 10-300 10-250 Output voltage scope (V)
-
Page 6: Installation
To 3-phase 380V TIG 160/200 P TIG 250/300 P Flow adjuster ① ④ ④ ③ ① ③ GAS IN ② GAS IN Electrode holder Power Input Terminal Grounding Terminal TIG welding gun Air Faucet Earth clamp The connection diagram of the welder is shown above. Be sure to use this welding machine with the specified welding gun, earth clamp together;... -
Page 7: Operation Instruction
Operation Instruction Front Panel Name and Function LED digital tube ① Parameter regulation knob ② Parameter storage key ③ Parameter call key ④ Pulse frequency regulation indicator ⑤ SAVE ⑥ Duty cycle regulation indicator PROG ⑦ Base value current regulation indicator ⑧... - Page 8 - TIG/TIG Pulse/MMA mode : Push button to choose a welding mode - Control buttons: rotary control to adjust the values of the parameters chosen keys. - 2T/4T button: “2T” n is short welding, pressing button will power up when released, stop power supply.
- Page 9 3-3. Operation Steps of Pulse TIG Welding - Connect the welding machine to the input power supply and power the welding machine on. In such case, power on the machine and let it have a self-check; and the screen will display: Full display->HYL->Model such as 200-> Enter the previous welding status.
-
Page 10: Safety Requirements
Precautions 4-1. Workspace 1. welding equipment free of dust, corrosive gas, non-flammable materials, up to 90% humidity for use! 2. Avoid welding outdoors unless protected from direct sunlight, rain, snow, work area tempera- ture must be between -10 ° C and +40 °. 3.