Flyzone HADRON Manual page 7

Optional: Install the Canopy Hook
Bold pilots who have the courage to fl at-spin the Hadron suddenly and violently are advised to install the optional canopy
hook for additional canopy security. Pilots who fl y the Hadron "normally" (performing traditional aerobatics and speed fl ying)
need not install the hook.
1. Cut the sharp edges off the opening of the rubber band
hook, then glue the hook to the base with CA.
3. Use a small hex key wrench or similar to loop the included rubber band under the fuselage tube, then pull the ends up.
4. Connect the ends of the rubber band to the hook. When removing the canopy to exchange batteries between fl ights, no
need to unhook the rubber band—simply lift off the canopy and swing it to the side.
2. Use medium-grit sandpaper to roughen the inside of the
canopy where the hook is to be glued. Use CA to securely
glue the base into position where shown.
7