Flyzone HADRON Manual page 3

ASSEMBLY
Program Your Transmitter
1. Remove the turtledeck and set aside.
Motor
rotates
right
Both elevons up
2. Connect the servos and ESC to your receiver and power up the system with a battery so you can operate the servos and motor
(if not done so already, this may also require linking the receiver to your transmitter). Program your transmitter and connect the
servos to the receiver so the controls respond correctly to stick movements—if using the TTX650 simply follow the programming
instructions and connect the servos into the receiver as instructed on page 11. Note: If the ESC beeps continuously and
you cannot get the servos to respond, the ESC requires calibration to detect the throttle stick endpoints. Follow the Throttle
Calibration procedure on page 13.
IMPORTANT!: If using a Tactic radio, be certain to link the receiver to the transmitter after the throttle channel has been
reversed. Otherwise, the motor will switch to full-throttle when signal is lost (i.e., if the transmitter is accidentally turned off
before disconnecting the battery from the ESC).
Rudder servo
arm rotates
counter-
clockwise
3
Motor turns clockwise
Left elevon down Right elevon up