Mount The Battery - Flyzone HADRON Manual

7. When all of the controls are hooked up and working properly, mount the receiver with the included adhesive-back hook & loop material.
8. The pushrods are connected to achieve the correct high-rate control throws with the end points in your transmitter set to 100%.
You could measure and check the throws (provided on page 12), or simply program your low-rates to 60% and the throws will
be close enough for you to fi ne tune from there. While you're at it, your Hadron will also benefi t from -30% exponential on high-
rate and -20% exponential on low-rate (negative values apply to Futaba and Tactic radios—control response should be softer/
less-sensitive around center stick).

Mount the Battery

IMPORTANT: If performing fl at spins or other rigorous maneuvers, the 4S battery must be captured by two straps. It is also
critical that the straps (for 3S or 4S batteries) wrap over the top and down the side as illustrated on the following page. If the
location of your battery does not align with two of the "channels" for two straps, an additional channel can be easily cut under
the tube with a hobby knife for that second, important strap.
5