Select A Gps Source - Humminbird 1100CI Series Installation And Operation Manual

Select a GPS Source

When you power on the network for the first time, the control head will automatically choose the connected or internal GPS receiver
to provide data to the control head. Use the instructions below to change the GPS source for the selected control head.
Select a GPS Source
1. Open the Network Source Setup dialog box.
2. Select the GPS Tab.
3. Select: Press the DOWN or UP Cursor keys to choose a source.
4. Press the RIGHT Cursor key or the CHECK/INFO key to select it (check mark = selected).
5. Save: Press the EXIT key twice to close the dialog box. Network settings are saved even after the unit is powered off.
6. Repeat the steps in this section on each control head to choose a GPS source for each tab. You can select the same source
or a different source.
Local Setup: To use separate GPS receivers for each control head, repeat these steps on each control head until you've set a
GPS receiver for each unit.
Shared Setup: To use the same GPS receiver with more than one control head, repeat these steps on each control head and
select the same GPS receiver on all units.
The control head
detects all GPS sources
in the network.
NOTE: The current GPS Fix is reported as No Fix, Fixed, or Enhanced. An Enhanced Fix has been augmented using information from
WAAS, EGNOS, or MSAS. An Enhanced Fix is required for navigation.
Selecting a GPS Source
unit name unit model
column number
(see Customize column (internal or
the Unit Name)
29
GPS type GPS Fix
column column
external)
GPS tab
selected
GPS Source & Sharing Waypoints