Install An Ethernet Connection - Humminbird 1100CI Series Installation And Operation Manual

1. I E
NSTALL AN THERNET
If your Humminbird control head has a built-in Ethernet connector, the unit can be connected to the Ethernet network. When you
connect the units together, data is shared between the two units.
Before you start, please note that the Ethernet network installation has the following requirements:
• Update Software: Your model may require a software update to enable Ethernet. Log in to your account at humminbird.com
to download the latest software update. For assistance, contact Customer Service.
• Install the control heads and sources (GPS, transducers, temp/speed accessories, etc.) for your Fishing System. See the
equipment installation guides for details.
• Purchase Ethernet Connection Cables (separate purchase required): Your network configuration and Ethernet port shape will
determine which Humminbird connection cables you will need to purchase.
Purchase Ethernet Cables and Equipment
1. Review the illustrations on the following pages. Find your control head models and locate the Ethernet port on each control
head.
The shape of the Ethernet port determines the cable(s) you need to purchase, as shown in the following table. The Ethernet
port will be round or shaped like an hourglass.
Control Heads
(2) Units with Hourglass-shaped Ethernet Ports
(1) Unit with an Hourglass-Shaped Port and (1) Unit
with a Round Ethernet Port
(2) Units with Round Ethernet Ports
NOTE: The AS EC [length]E cable is available in a variety of lengths. To purchase the Ethernet Cables and extension cables, visit
our Web site at humminbird.com. To network more than two units, purchase the Humminbird AS ETH 5PXG.
Installation
C
ONNECTION
Ethernet Cable Information
Required Cables
(2) AS EC QDE & (1) AS EC [length]E
(1) AS EC QDE & (1) AS EC [length]E
(1) AS EC [length]E
8