Change From A Lost Temperature Source - Humminbird 1100CI Series Installation And Operation Manual

Change from a Lost Temperature Source

To change the temperature source after the network has been configured, open the Network Source Setup dialog box to change the
temperature sources at any time (see Select a Temperature Source). Network settings are saved even after the unit is powered off.
• Temperature Graph (1100 Series, HELIX Series): Temperature Source 1 provides the data for the temperature graph on the
display. When the temperature source is changed, the temperature graph displays a red mark to show where the temperature
source was changed.
NOTE: The Temperature Graph menu setting is not shared on the network. It is a local menu setting.
• If the control head cannot detect the set temperature source, the digital readout box will flash. If the digital readout box is
blank, the source has been lost. Open the Network Source Setup dialog box to assign a temperature source to the digital
readout box. See Select a Temperature Source for details.
Temperature Sources
Temperature Source Lost (1100 Series)
The Temp 2 (T2) Source is not detected on the network.
26