Safety Information - Hubbell Geyser-RO Installation & Owner's Manual

Please read carefully to prevent serious accidents or injury
The Geyser-RO Heat Pump Water Heater must be installed in the accordance with Local and National
codes as well as the installation instructions in this manual. Before beginning the installation, carefully
read the entire manual and check the local, state, and national codes regarding building, electrical, and
plumbing installations, or check with your local authorities for clarification of these codes. Failure to
install the Geyser-RO in accordance with these codes and the installation manual may result in property
damage, bodily injury or death.

Disconnect all power before installing or servicing the Geyser-RO.

There is a discharge fan located on the unit. Extreme caution must be exercised to ensure that any
foreign objects including fingers and hands remain clear of the fan area.

Do not stand, sit or place any objects on or beside the unit (clearances are stated in the installation
manual).

Do not allow children to play on or near the unit.

Make sure all power is disconnected and shut off before moving the unit.

Cover should not be removed with power on.

Internal components may be HOT. Please allow sufficient time for the unit to cool completely
before touching any internal components.

Ensure that the power receptacle for the Geyser-RO is rated for 115 VAC and at least 15 A.

Ensure that the electrical supply has a properly rated fuse or circuit breaker protection rated for at
least 15 A. It is suggested to use a dedicated outlet.

Always wear eye protection during installation.

Unit weight is approximately 70lbs. All lifting should be done with the handles located on the side
of the Geyser-RO. Proper lifting should be used in the moving of the unit.

Do not turn on power to the Geyser-RO unless the A419 temperature sensor is installed to Nyle
Systems specifications. Failure to do so will void the warranty and could cause severe injury or
death.

Read all supplied literature including the Johnson Controls Owner's Manual before installation.
Please keep these instructions for reference!

SAFETY INFORMATION

.
2