Table of Contents
Advertisement
Turning Off the Power
1.
Before you turn off the power, check the following.
Have you turned down the volume of the VP-770 and the connected audio system to the minimum
settings?
2.
On the VP-770's rear panel, turn the [POWER ON] switch "off ."
✍
If you need to turn off the power completely, fi rst turn off the [POWER ON] switch, then unplug the
power cord from the power outlet. Refer to "Power Supply" chapter in "USING THE UNIT SAFELY"
(separate document).
Adjusting the Display Contrast
The characters in the display may be diffi cult to view immediately after turning on the VP-770's power
or after extended use. If this occurs, turn the rear panel [DISPLAY CONTRAST] knob to make the display
legible.
About the Top Screen
The screen that appears fi rst when you turn on the power shows the following information.
You can select a registration or sound by using the cursor buttons to move the cursor to each item and
then turning the value dial.
*
Please be aware that in the screen shots shown in this document, the registration names and tone
names diff er from the factory settings.
( DISPLAY CONTRAST)
Information
Registration number
Tone of the Vocal Designer part
Tone of the Ensemble part
Page
p. 78
p. 27
p. 42
25
Advertisement
Table of Contents
