Table of Contents
Advertisement
Turning On/Off the Power
Here's how to turn the VP-770's power on or off .
Turning On the Power
*
After completing the connection explained in the previous chapter, make sure to turn on the power
by following the steps below. By turning on devices in the wrong order, you risk causing malfunction
and/or damage to speakers and other devices.
1.
Before you turn on the power, check the following.
Is the VP-770 correctly connected to your peripheral equipment?
Have you turned down the volume of the VP-770 and the connected audio system to the minimum
settings?
2.
On the VP-770's rear panel, turn the [POWER ON] switch "on."
*
This unit is equipped with a protection circuit. A brief interval (a few seconds) after power up is
required before the unit will operate normally.
3.
Use the [VOLUME] knob to adjust the volume appropriately.
While you play the keyboard to produce sound, adjust the volume of the VP-770 and of the audio
equipment you've connected.
If You Don't Hear Sound, Check the Following
•
Is the VP-770 correctly connected to your amp, speaker, or headphones?
•
The Vocal Designer part won't produce sound when you play the keyboard unless you are vocalizing
into the microphone. ➞ For details, refer to "Performing with Vocal Designer" ( ➞ p. 27)
•
If there's no microphone connected, try selecting an Ensemble part sound and playing it from the
keyboard ( ➞ p. 42).
24
( POWER ON)
Advertisement
Table of Contents
