Roland VP-770 Owner's Manual page 91

Parameter Value
Uni Key Shift NONE
(BRASS SECTION *1 tone
FIXED
only)
AUTO
Auto Dynamics 0–127
(STRING SECTION *1 tone
only)
Section Size 0–127
(STRING SECTION *1 tone
only)
Variation NORMAL
(BRASS, STRINGS tone only)
STACCATO
(BRASS tone only)
FALL
(BRASS tone only)
DOIT
(BRASS tone only)
PIZZICATO
(STRINGS tone only)
TREMOLO
(STRING SECTION *1 tone
only)
Reverb Switch ON, OFF
(BRASS, STRINGS tone only)
EQ Switch BYPASS
(BRASS, STRINGS tone only)
ON
EQ Lo Freq 200, 400 Hz
(BRASS, STRINGS tone only)
EQ Lo Gain -15 –+15 dB
(BRASS, STRINGS tone only)
EQ Hi Freq 2000, 4000,
(BRASS, STRINGS tone only) 8000 Hz
EQ Hi Gain -15 –+15 dB
(BRASS SECTION,
SOLO BRASS,
STRING SECTION,
SOLO STRINGS tone only)
*1 For the BRASS SECTION and STRING SECTION sounds, refer to the separate "VP-770 Sound List. "
Description
All brass sounds of the brass section will be played by the same key (pitch).
Each brass sound will be played by the specifi ed key.
Sounds will be played by the key specifi ed for each brass sound only when
playing single notes in Unison mode.
This allows string-like expression to be played by adjusting the timing and
speed at which you take your fi nger off the key.
The volume will swell slightly when you take your fi nger off the key while
holding down the Hold pedal.
The sound will swell more greatly if you release your fi nger slowly. The
change will be greater for higher settings of this parameter value.
This is valid when the Hold Mode setting is "NORMAL" or "LEGATO. "
Specifi es the size of the string section. Higher values will simulate a larger
section. This can be set in a range from a string ensemble of a few members
up to a full orchestra.
The normal sound will be heard.
The staccato sound will be heard.
The fall sound will be heard.
The doit sound will be heard.
The pizzicato sound will be heard.
The tremolo sound will be heard.
Turns on/off the reverb that is applied only to brass and string sounds.
* The brass and string sounds have their own reverb eff ect that is separate
from the ambience that is applied to the overall sound of the VP-770.
Turns the equalizer off .
Turns the equalizer on.
Specifi es the center frequency at which the low-frequency range will be
adjusted.
Specifi es the gain (amount of boost or cut) for the low-frequency range.
Specifi es the center frequency at which the high-frequency range will be
adjusted.
Specifi es the gain (amount of boost or cut) for the high-frequency range.
91