JAI CV-M10BX Operation Manuals page 28

2) Internal HD/VD output Mode
To change the Internal Sync Input Mode to Output Mode, make the
following modifications on PK8078. (Factory setting is at the
external sync input mode.)
- HD Output
:
Make the jumper register at R41 opened, and the jumper at JP7
short-circuited.
- VD Output
:
Make the jumper register at R40 opened, and the jumper at JP5
short-circuited. (VD Output)
3) Pixel clock output
To use pixel clock output (4.0Vp-p), make the jumpers R19 short-circuited and R20
to open-circuited on PK8079 board. The position of jumper is described
as follow.
Pixel clock pulse will be available at pin no.9 of 12P Multi connector.
(see 5. Pin Assignment.)
1.Due to the output of pixel clock pulse, noise level may increase. Therefore, it is
recommended to check the noise level at your system installation.
2.Video-2 output Is not effective at this mode.
PK8079A - n
CV-M10
R20
- 22 -
R40
JP5
JP7