Biotek Synergy HT Operator's Manual page 71

Open the
4.
standards to the plate.
5. Open the
include Transformation, Well Analysis, Curve Analysis, Cutoff, and
Validation.
6. Create a report or export template, via the
Builder
7. Select
The instructions below briefly describe how to create a simple Experiment and then
read a plate in Gen5. See Gen5's Help system for complete instructions.
To create an
Select
1.
2. Select the desired protocol and click
3. Highlight a plate in the menu "tree" and select
Reading dialog will appear.
4. Click
already extended).
5. Place the plate on the carrier and click
6. When the read is complete, measurement values will appear in Gen5. To
view them, select the desired data set (e.g., "528/20,645/40") from the
drop-down list.
7. Select
Synergy HT Operator's Manual
dialog and assign blanks, samples, controls, and/or
Plate Layout
Data Reduction
, or Power Export Builder
File|Save As and give the file an identifying name.
and read a plate using Gen5:
Experiment
File|New Experiment
READ . The door will open and the carrier will extend (if it is not
File|Save As and give the file an identifying name.
dialog to add data reduction steps. Categories
Report Builder
options.
.
OK .
Plate|Read
OK to begin the read.
49
Gen5™ Software |
, File Export
. The Plate
Data