Table of Contents
Advertisement
Power Button
The Power Button connection is
located on pins 1 and 2 of JF1. Mo-
mentarily contacting both pins will
power on/off the system. To turn off
the power when set to suspend mode,
depress the button for at least 4 sec-
onds. Refer to the table on the right
for pin definitions.
Standby Power Header
The +5V Standby Power header is lo-
cated at JSTBY1 on the serverboard.
See the table on the right for pin defi-
nitions. (You must also have a card
with a Standby Power connector and
a cable to use this feature.)
Universal Serial Bus (USB)
Four Universal Serial Bus ports (USB
0/1, USB 2/3) are located on the
rear I/O. In addition, a USB header
located close to the P1-DIMMC1 slot
provides two front-accessible USB
connections (USB 4/5). One Type A
connector (USB9), located next to the
USB 4/5 header, also provides front
panel USB support (cables are not
included). See the tables on the right
for pin definitions.
Chapter 5: Advanced Serverboard Setup
Power Button
Pin Definitions (JF1)
Pin#
Definition
1
Signal
2
Ground
Standby PWR
Pin Definitions
Pin#
Definition
1
+5V Standby
2
Ground
3
Not Connected
Rear USB
(0/1,2/3)
Pin Definitions
Pin# Definition
1
+5V
2
PO-
3
PO+
4
Ground
5
NA
FP USB (2.0) (#4/5)
Pin Definitions
USB 4
Pin # Definition
1
+5V
2
PO-
3
PO+
4
Ground
5
Key
5-17
Type A USB 9
Pin Definitions
Pin# Definition
1
+5V
2
PO-
3
PO+
4
Ground
USB 5
Pin # Definition
1
+5V
2
PO-
3
PO+
4
Ground
5
Ground
Advertisement
Table of Contents
