Supermicro SUPERSERVER 6027R-CDNRT+ User Manual page 104

S S
UPER ERVER 6027R-CDNRT+ User's Manual
Staggered Spin-Up
Select Enabled to enable Staggered Spin-up support to prevent excessive
power consumption caused by multiple HDDs spinning-up simultaneously.
The options are Enabled and Disabled.
RAID Mode
The following items are displayed when RAID Mode is selected:
SATA RAID Option ROM/UEFI Driver
Select Enabled to support onboard SATA RAID Option ROM which will allow
the user to bootup the system using a SATA RAID device. Select Disabled
for UEFI device support. The options are Enabled and Disabled.
Port 0~5 Hot Plug
Select Enabled to enable hot-plug support for the particular port, which will
allow the user to change the device installed in a port specified by the user
without turning off the system power. The options are Enabled and Disabled.
SCU (Storage Control Unit) Configuration
Storage Controller Unit
Select Enabled to enable PCH SCU storage devices. The options are Disabled
and Enabled.
SCU RAID Option ROM/UEFI Driver
Select Enabled to support onboard SCU RAID Option ROM which will allow the user
to bootup the system using a SCU RAID device. Select Disabled for UEFI device
support. The options are Enabled and Disabled.
PCIe/PCI/PnP Configuration
Launch Storage OpROM Policy
Use this feature to select the device which you want to use Option ROM to boot the
system from when there are multiple Option ROM devices available in the system.
The options are Legacy Only and UEFI Only.
PCI Latency Timer
Use this feature to set the latency Timer of each PCI device installed on a PCI bus.
Select 64 to set the PCI latency to 64 PCI clock cycles. The options are 32, 64, 96,
128, 160, 192, 224 and 248 (PCI Bus Clocks).
7-16