Installing The Rs-232 Board - Tait TM8200 Accessories Manual

3.2

Installing the RS-232 Board

3.2.1 Parts Required
3.2.2 Installation Procedure
36 TMAA01-02 RS-232 Board
The following table describes the parts required to install an RS-232 board in
a radio. The parts marked with an asterisk ( * ) are not shown in
are used to connect to the radio's external options connector.
Table 3.1 RS-232 installation parts required
Quantity Internal Part Number
1 362-01111-XX
1 362-01108-XX
2 347-00011-00
2 354-01043-00
4 349-02062-00
1 240-00034-00
*
1 240-06010-29
*
a. Contact Technical Support for the exact IPN.
1. Disassemble the radio in order to gain access to the options cavity.
For detailed disassembly instructions, refer to the disassembly proce-
dure in the service manual.
Refer to the diagram on the following page and the instructions below.
2. Remove the top cover and lid
options cavity.
3. Remove the external options connector bung
4. On the inside of the radio lid place the foam seal
options connector cavity
5. Plug one end of the internal options connector loom into the internal
options connector on the RS-232 board.
6. With the top side of the RS-232 board
the external options connector
RS-232 board) into the external options connector cavity.
Important
The external options connector screw-lock fasteners must
be tightened correctly before screwing the RS-232 board
onto the mounting posts
7. Screw the external options connector to the radio lid using the two
screw-lock fasteners
Tighten the fasteners to a torque of 0.9N·m (8lbf·in).
Description
a
foam seal
a
cover seal
4-40x3/16 screws
screw-lock fasteners
M3x8 screws
D-range plug
D-range hood
b
from the radio to access the
e
.
f
g
(the D-range connector on the
i
.
h
.
© Tait Electronics Limited August 2005
Figure 3.1
Figure 3.1
Reference
d
1!
1@
h
j
—
—
c
, if it is fitted.
d
over the external
facing the radio lid, guide
TM8100/TM8200 Accessories Manual
and