Radio Programming - Tait TM8200 Accessories Manual

7.2

Radio Programming

66 TMAA02-07 Concealed Microphone
Important
To maintain the IP54 protection class, great care must be
taken when installing the microphone capsule and seal
into the concealed-microphone cavity.
3. Push the microphone capsule and
seal into the concealed-
microphone cavity.
4. On the control head PCB, solder
the negative wire to the
COV MIC- pad
concealed-microphone wire to the
COV MIC+ pad
Note
The positive wire on the micro-
phone capsule is identified by a
red stripe.
5. Re-install adaptor flange onto the control head.
6. Plug the control head loom
onto the control
head connector
7. Insert the bottom edge of the
control head onto the two clips
in the front of the radio
chassis , then snap
2
into place.
When the concealed microphone is installed in a radio for use in emergency
situations, a field in the UI Preferences form, Audio tab of the programming
application may need to be selected.
Emergency Mic: select Concealed.
Refer to the online help of the programming application for more information.
e
and the positive
f
.
.
1
d e f
2
1
2
TM8100/TM8200 Accessories Manual
© Tait Electronics Limited August 2005
d