Operation Disturbances; Regular Maintenance Of Equipment; Disposal Of The Machine - Kemppi Kempoweld Wire 550 Operating Instructions Manual

7. OPERATION DISTURBANCES

The amount of use and the working environment should be taken into consideration when planning the frequency
of maintenance of the wire feeder unit. Careful use and preventive maintenance will help to ensure trouble-free
operation.
The following maintenance operations should be carried out at least every six months:
Check:
– The wear of the grooves of the feed rolls. Excessive wear of grooves causes problems in wire feed.
– The wear of the wire guide tubes of the wire feeder unit. Badly worn feed rolls and wire guide tubes should
be discarded.
– The wire guide tube in the gun should be set as near the feed rolls as possible, but not touching them and
the wire must follow a straight line from the end of the tube to the groove of the feed roll.
– Reel brake adjustment.
– Electric connections
* Oxidezed couplings must be cleaned
* Loose couplings must be tightened
Clean dust and dirt from the equipment.
In case of problems contact your Kemppi dealer.
When using compressed air, always protect your eyes with proper eye protection.

7.1. REGULAR MAINTENANCE OF EQUIPMENT

Kemppi service repair shops make regular maintenance according to agreement.
The major points in the maintenance procedure are listed as
follows:
– Cleaning of the equipment
– Checking and maintenance of the welding tools
– Checking of connectors, switches and potentiometers
– Checking of electric connections
– Metering units checking
– Checking of mains cable and plug
– Damaged parts or parts in bad connection are replaced by new ones
– Maintenance testing. Operation and performance values of the equipment
are checked, and adjusted when necessary by means of test equipment.

7.2. DISPOSAL OF THE MACHINE

Do not dispose of electrical equipment together with normal waste!
In observance of European Directive 2002/96/EC on Waste Electrical and Electronic Equipment and
its implementation in accordance with national law, electrical equipment that has reached the end of its
life must be collected separately and returned to an environmentally compatible recycling facility. As
the owner of the equipment, you should get information on approved collection systems from our local
representative.
By applying this European Directive you will improve the environment and human health!
12 – KEMPOWELD WIRE 400, 550 / 0530
twice a year
© COPYRIGHT KEMPPI OY