Table of Contents
Advertisement
Section 5
System setup
5.13.7
314
Confirm press ENTER
Cancel press EXIT.
5.
Press the ENT pushbutton. The following sequence of screens will be displayed:
Bluetooth Pass Reset Resetting -WAIT-
Cancel press EXIT.
Bluetooth Pass Reset Ready Press ENTER
The Passkey is now set to NONE and Authentication is disabled.
6.
To assign a NEW Passkey, press the Up/Down arrow pushbutton, as necessary, until
the "Authentication" menu item is displayed.
7.
Press the ENT pushbutton. If prompted, enter a valid Level 2 Access Code. The
following will be displayed:
Authentication disable C
8.
Utilizing the Up/Down arrow pusbuttons select "ENABLE", then press the ENT
pushbutton. The following will be displayed:
Please Enter Passkey _
9.
Utilizing the arrow pushbuttons enter the desired Passkey (up to 16 characters), then
press ENT. The following sequence of screens will be displayed:
Bluetooth Pass Reset Resetting -WAIT-
Bluetooth Pass Reset -DONE-
Bluetooth Pass Reset Ready Press ENTER
Resetting bluetooth passkey from TCC600
The Bluetooth Passkey can be reset if necessary.
1.
Select Communication/Setup/Bluetooth Settings from the TCC600® toolbar.
TCC600 will display the "Bluetooth Information" dialog screen.
2.
Select "Set Password". TCC600 will display the "Bluetooth Authentication
Password" dialog screen.
GUID-16FCDC4F-5A98-40AD-90E8-2DEB5412D45C V1 EN
Figure 246:
Bluetooth Authentication Password Dialog Screen
3.
Enter the "Old" Password and then enter the desired "New" Password (up to 16
characters).
1VAC388793-MB A
TCC300
User Manual
Advertisement
Table of Contents
