System Configuration Problems; Fibre Channel Problems - Qlogic QLA200 HBA User Manual

6 – Troubleshooting
Problems After Installation
6.1.2

System Configuration Problems

Is the motherboard configured properly?
■
6.1.3

Fibre Channel Problems

Were all of the FC devices powered up before you powered up the PC?
■
Are all the cables properly connected?
■
Have you configured your RAID controller using the utilities provided by the
■
manufacturer?
Is your switch configured correctly?
■
Is the data rate setting correct?
■
6-2
All PCI-compliant and PCI-X-compliant systems automatically detect 32-bit
HBAs and set the appropriate bus speed (for example, 33 MHz or 133 MHz).
Check the motherboard for proper configuration
documentation supplied with your computer, or contact your computer dealer
to determine if your motherboard requires special configuration.
Some Fibre Channel switches support zoning. Make sure that your switch is
configured correctly.
Make sure that data rate setting on the QLA200 (2 Gbps) matches the target
device setting.
(see section 2). Also see the
FL0054601-00 B