Advertisement
2018 Kawasaki KLX250S
I n s t a l l a t i o n I n s t r u c t i o n s
PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION
IFC17900.01
www.powercommander.com
2191 Mendenhall Drive North Las Vegas, NV 89081 (800) 992-4993 www.powercommander.com
Parts List
1
Power Commander FC
1
USB Cable
1
Installation Guide
2
Dynojet Decals
2
Velcro
1
Alcohol swab
1
Posi-tap
THE IGNITION MUST BE TURNED
OFF BEFORE INSTALLATION!
YOU CAN ALSO DOWNLOAD THE PCFC
CONTROL CENTER SOFTWARE AND
LATEST MAPS FROM OUR WEB SITE AT:
www.powercommander.com
2018 Kawasaki KLX250S - 1
Advertisement
Table of Contents
Related Manuals for Dynojet Power Commander FC
Summary of Contents for Dynojet Power Commander FC
- Page 1 Parts List Power Commander FC USB Cable 2018 Kawasaki KLX250S Installation Guide Dynojet Decals I n s t a l l a t i o n I n s t r u c t i o n s Velcro Alcohol swab Posi-tap THE IGNITION MUST BE TURNED...
- Page 2 SELECTING THE MAP POSITION The Dynojet Power Commander Fuel Controller (PCFC) comes loaded with up to ten maps. Using a #1 Phillips screwdriver, turn the map select dial to toggle between the loaded maps. Refer to the map position table for the maps included in your PCFC. USING THE RPM RANGE DIALS The Low, Mid, and High RPM Dials refer to the RPM range, in thirds, of your vehicle. Each dial allows +/- 10% fuel adjustment on top of what fuel changes are done in the STATUS Light map. With the dial facing straight up, there is no additional fuel change. For example, if your vehicle revs to 6000 RPM: • The low RPM dial will adjust 0-2000 RPM • The mid RPM dial will adjust 2001-4000 RPM MAP Select • The high RPM dial will adjust 4001-6000 RPM LOW RPM Dial USING PCFC CONTROL CENTER USB Port MID RPM Dial Take your tuning to the next level with the PCFC Control Center software. HIGH RPM Dial Using your web browser, navigate to www.powercommander.com.
- Page 3 Remove the seat, all side panels, and the fuel tank. FIG.A Secure the PCFC module to the side of the battery with the supplied Velcro (Fig. A). Clean surfaces with the alcohol swab before attaching the Velcro. Secure the PCFC ground wire with the small ring terminal to the negative (-) terminal of the bike’s battery. Route the pair of 4-pin connectors towards the top of the rear fender. Route the other wiring harness branch with the pair of 2-pin connectors towards the throttle body.
- Page 4 FIG.D Unplug Locate and unplug the Fuel Injector at the top of the throttle body (Fig. D). FIG.E Plug the pair of 2-pin PCFC connectors in-line with the Fuel Injector and the stock wiring harness (Fig. E). FIG.F Use the supplied Positap to attach the unterminated GREY wire of the PCFC wiring harness to the stock LIGHT BLUE wire of the Throttle Position Sensor connector on the stock wiring harness (Fig. F). The bike’s TPS is on the left side of the throttle body. Reinstall the fuel tank, bodywork, and the seat. IFC17900.01 www.powercommander.com 2018 Kawasaki KLX250S - 4...
Need help?
Do you have a question about the Power Commander FC and is the answer not in the manual?
Questions and answers