Replacing The Autosampler Firmware - Agilent Technologies G1367A Reference Manual

Replacing the Autosampler Firmware

The installation of new firmware is required:
• if new version solves problems of currently installed version.
• if after exchange of the mainboard (MTP) the version on board is older than
To upgrade the autosampler firmware the following steps have to be
performed:
1 Load the firmware into the autosampler, see the help system of your user
2 If the sampler main board was replaced, re-enter the serial number
1100 Series WS MWS Reference Manual
previous installed one.
interface.
For control module see
information of the module trough the user interface, see
Serial Number using the Control Module"
Serial Number using the ChemStation"
"Firmware Update"
on page 148 or
on page 148.
Repairing the Sampler
on page 269
"Entering the
"Entering the
4
155