2.5 Power On/ Power Off; Starting The Operation; Closing The Operation And Shutting Down - GE SpotChecker Operating Manual

Power on/Power off

2.5 Power on/ Power off

Starting the operation

To start the SpotChecker press the switch-on but-
ton at the down right of the display. The instrument is
switched on and the operating system Windows XP
boots up. The green LED illuminates during operation.
After start of the software the SpotChecker is ready
for testing operation.

Closing the operation and shutting down

A
Attention:
Always close the software fi rst before shutting down
the instrument. Not following this sequence may result
in a loss of data.
– Select the menu item Exit from the menu File.
All current settings are saved and the program is
closed.
SpotChecker
– Click the button Start in the taskbar and select the
menu item Shut Down to shut down the Windows
operating system.
– After Windows is closed down, the SpotChecker
will switch off automatically.
Note:
H
To switch off the SpotChecker without shutting down
the software or the operating system, you have to
keep the button on the front panel depressed for at
least 4 seconds.
Switching off without shutting down the software may
be required as severe exception, e.g. if the instrument
does no longer react. All unsaved data are lost in such
a case.
Issue 02, 03/2009
Initial start-up and basics
33