Applying +48V To Inputs - Yamaha PM5D-RH Quick Start Manual

Applying +48V to inputs.

On the regular PM5D model the +48V switch is located above the analog gain pots but the layout is different for the
PM5D-RH.
There is no dedicated +48V switch in the selected channel.
There are two different ways to approach this;
This button turns on +48V
when encoder is selected
as GAIN. (Preference for
[ENCODER-ON AS +48V] in
PREFERENCE 1 must be set.)
PM5D / PM5D-RH Quick Start Guide Part 1
1) Screen method;
DISPLAY ACCESS > HA/INSERT > CH 1-24. On this page
you can select +48V for the fi rst 24 channels and so on.
2) Encoder mode method;
This needs a preference setting in UTILITY > PREFERENCE
1. In the right hand column is a preference for; [USE
ENCODER-ON AS +48V]. Now whenever the encoder
mode is set to GAIN/ATT, the ENCODER [ON] button will
activate +48V. Phantom is clearly indicated with a red
LED near the preamp inputs and meters.
+48V MASTER switch!!
There is a physical +48V MASTER switch on the rear
panel of PM5D-RH.
17