Table of Contents
Advertisement
The wireless controller has previously been registered to the digital mixer at the
factory, if communication problems are encountered, a re-registering of the wireless
controller may be required.
A re-registering of the wireless controller must also be performed should the control
PCB in the Digital Mixer Valve be replaced.
To re-register the wireless controller to the Digital Mixer Valve carry out the following
sequence.
Isolate power to the Digital Mixer
Valve.
Press " + " and "
simultaneously until "End" is
displayed on the screen.
Restore power to the digital mixer
valve.
Briefly press the " + " and " " buttons,
"SET" will be displayed on the screen.
Note! if display reads "Err" press " "
and repeat the process.
1144486-W2-K
RE-REGISTERING
" buttons
34
Hide quick links:
Advertisement
Table of Contents
