Mira Vier Installation Manual page 29

Place the backplate over the outlet
pipe with the arrow pointing vertically
up and tighten the two backplate
screws. Make sure that the foam seal
abuts the finished wall surface.
Fit the olive and the backplate nut over
the outlet pipe, do not tighten the nut
fully at this point.
Check that the 'O' seal is fitted to the
outside of the backplate nut. Press the
elbow onto the backplate, make sure
that the clips on the elbow engage
with the backplate.
To prevent the backplate from turning
while tightening the nut, fit the retaining
ring over the backplate nut making
sure the slots engage with the screws
on the backplate, hold the retaining
ring with a wrench while tightening the
backplate nut. Remove the retaining
ring after use.
Slide the retaining ring over the elbow
and engage with the elbow clips. Note!
The retaining ring must be engaged
correctly to lock the elbow to the
backplate, rotate the retaining ring to
the postition illustrated.
Press the shroud over the elbow, make
sure that it engages with the lugs on
the backplate.
Place first washer in end of hose,
then attach to elbow. Do not fit
showerhead until after pipework has
been fully flushed through. See section
"Commissioning".
Copper
Pipe
29
Backplate
2 x Screws
Copper
Backplate
Pipe
Nut
Olive
Retaining
Ring
Backplate
Foam Seal
Elbow
Retaining Ring shown
correctly engaged with
Elbow
1
2
1144486-W2-K