Alcatel-Lucent 7750 SR OS Interface Configuration Manual page 440

Configuration Commands
ccm-ltm-priority
Syntax ccm-ltm-priority priority
no ccm-ltm-priority
Context config>eth-tunnel>path>eth-cfm>mep
Description This command specifies the priority value for CCMs and LTMs transmitted by the MEP.
The no form of the command removes the priority value from the configuration.
Default
The highest priority on the bridge-port.
Parameters
priority — Specifies the priority of CCM and LTM messages.
eth-test-enable
Syntax [no] eth-test-enable
Context config>eth-tunnel>path>eth-cfm>mep
Description This command enables eth-test functionality on MEP. For this test to work, operators need to
configure ETH-test parameters on both sender and receiver nodes. The ETH-test then can be done
using the following OAM commands:
oam eth-cfm eth-test mac-address mep mep-id domain md-index
association ma-index [priority priority] [data-length data-length]
A check is done for both the provisioning and test to ensure the MEP is an Y.1731 MEP (MEP
provisioned with domain format none, association format icc-based). If not, the operation fails. An
error message in the CLI and SNMP will indicate the problem.
test-pattern
Syntax test-pattern {all-zeros | all-ones} [crc-enable]
no test-pattern
Context config>eth-tunnel>path>eth-cfm>mep>eth-test-enable
Description
This command configures the test pattern for eth-test frames.
The no form of the command removes the values from the configuration.
Parameters
all-zeros — Specifies to use all zeros in the test pattern.
all-ones — Specifies to use all ones in the test pattern.
crc-enable — Generates a CRC checksum.
Page 440
Values
0 — 7
Default all-zeros
7750 SR OS Interface Configuration Guide