Alcatel-Lucent 7750 SR OS Interface Configuration Manual page 278
7750 sr series
Hide thumbs
Also See for 7750 SR OS:
- Manual (1948 pages) ,
- Service manual (1506 pages) ,
- System configuration manual (484 pages)
Table of Contents
Advertisement
Configuration Commands
bundle-id — Specifies the multilink bundle to be associated with this IP interface. The command
For example:
router1>config# port bundle-1/1.1 (multilink PPP bundle)
aps-id — This option configures APS on un-bundled SONET/SDH ports. All SONET-SDH port
Page 278
Syntax: bpgrp-type-bpgrp-num
bpgrp:
type:
bpg-num:
Example: port bpgrp-ima-29
syntax must be configured as follows:
Syntax:
bundle-type-slot/mda.bundle-num
bundle-ppp-slot/mda.bundle-num (Creates a multilink PPP bundle.)
bundle:
slot:
bundle-num:
parameters, with certain exceptions, for the working and protection circuit ports must be
configured in the config>port>aps-group-id context. The working and protection circuit ports
inherit all those parameters configured. The exception parameters for the working and protect
circuits can be configured in the config>port>sonet-sdh context. Exception list commands
include:
clock-source
[no] loopback
[no] report-alarm
section-trace
[no] threshold
When an aps-group-id is created all applicable parameters under the port CLI tree (including
parameters under any submenus) assume aps-group-id defaults, or when those are not explicitly
specified, default to SONET/SDH port defaults for any SONET port.
.All but a few exception SONET/SDH parameters for the working channel port must be
configured in the config>port>aps>sonet-sdh context. The protection channel inherits all the
configured parameters. The exception parameters for the protection channel can be configured in
the config>port>aps>sonet-sdh context.
Signal failure (SF) and signal degrade (SD) alarms are not enabled by default on POS interfaces.
It is recommended to change the default alarm notification configuration for POS ports that
belong to APS groups in order to be notified of SF/SD occurrences to be able to interpret the
cause for an APS group to switch the active line.
For path alarms, modify the logical line aps-id in the configure port aps-id sonet-sdh path
report-alarm
context. For example:
configure port aps-1 sonet-sdh path report-alarm p-ais
keyword
ppp — Provides protection of one PPP bundle by another.
ima — Provides protection of one IMA bundle by another IMA
bundle.
1 — 1600
keyword
card/mda slot numbers
1 — 256
7750 SR OS Interface Configuration Guide
Advertisement
Table of Contents
