Teaching-In; Pairing With A Homematic Ip Floor Heating Actuator - HomeMatic HmIP-MIOB Installation Instructions And Operating Manual

6.4

Teaching-in

Please read this entire section before starting
the teach-in procedure.
To integrate the Multi IO Box into your system and
enable it to communicate with other devices, you must
connect it first.
You can either pair the Multi IO Box directly with the
Homematic IP Floor Heating Actuator or teach it in
to the Homematic IP Access Point. If you teach-in the
device to the Access Point, configuration is done via the
Homematic IP app.
6.4.1 Pairing with a Homematic IP Floor Heating
Actuator
Please make sure you maintain a distance of at
least 50 cm between the devices.
You can cancel the pairing procedure by briefly
pressing the system button (A) again. This will be
indicated by the device LED lighting up red.
If you would like to integrate the Multi IO Box into
an existing system, you first have to activate the
pairing mode of the floor heating actuator and
afterwards the pairing mode of the Multi IO Box.
Start-up
57