HomeMatic HmIP-MIOB Installation Instructions And Operating Manual page 58

Start-up
If you want to pair the Muli IO Box with a Homematic IP
Floor Heating Actuator, the pairing mode of both devices
has to be activated first. To do this, proceed as follows:
• Press and hold down the system button (A) of
the Multi IO Box for at least 4 seconds to activate
the pairing mode (see figure 4). The device LED
flashes orange.
• Activate the pairing mode of your floor heating
actuator. Briefly press the select button until the
LEDs of all channels light up green.
• Press and hold down the system button of the floor
heating actuator for 4 s until the LED quickly starts
flashing orange (see fig. 5).
The device LED (A) lights up green to indicate that pairing
has been successful. If pairing failed, the device LED (A)
lights up red. Please try again.
If no pairing operations are carried out, pairing
mode is exited automatically after 3 seconds.
58