Connection Of The Device - Weller WQB 4000SOPS Quick Starter Manual

WQB 4000SOPS - Quick Starter Guide
2.3.1 Assembly of the split optical unit
The optical module is already pre-calibrated in the factory. It therefore only needs to be
assembled, checked and readjusted as required.
2.3.1.a Assembly: push the linear axis to the right-hand stop.
2.3.1.b Flange-mount the optical module and secure with 3 stud bolts from the rear and
tighten to a torque of 2 Nm
2.3.1.c Insert connector for optical unit lighting
Connector
2.3.2

Connection of the device

Mains voltage: observe the specifications on the type plate
Compressed air: 400 – 600 kPa pure, dry and oil-free compressed air (where possible,
with upstream maintenance unit)
Alternative: compressed air for vacuum generation, nitrogen (N
process
Only compressed air
From software version 2.17
Compres
Air
Nitrogen
(N
Version 1.2.6
)
2
Compressed air & nitrogen (N
Stud bolt
Strain relief
USB cable
) for the soldering
2
)
2
Page 3 of 8