Failure to observe the safety regulations results in a risk to putting the control unit into operation and observe the life and limb. safety precautions specified therein. Keep these instructions in a place that is accessible to all Only connect WELLER tools. • users. If the device is faulty, active electrical conductors may be bare or the PE conductor may not be functional. Safety information Repairs must always be referred to a Weller-trained •...
Soldering profiles must be configured so that the printed • vices which are included in the list of accessories or appro- circuit boards are cold on removal. ved for use by the manufacturer. Use WELLER accessories Wear gloves when removing the printed circuit boards. or auxiliary devices on original WELLER equipment only. The • Care must be taken to ensure that hot printed circuit boards use of other tools and other accessories can cause injury.
Page 16
Warning! Risk of burns! Check all connected cables and hoses on a regular basis. If power tools are damaged, they must be immediately removed from use. Do not use blocked nozzles. Read the operating instructions! Repairs must always be referred to a Weller-trained specialist. Before performing work of any kind on the unit, Use original replacement parts only. always disconnect the power plug from the socket.