Removing And Replacing The Hpe Smart Storage Battery; Removing And Replacing A Storage Controller - HPE Synergy 480 Gen10 series Maintenance And Service Manual

• UEFI System Utilities—Use System Utilities through the Remote Console to configure the compute
module for NVDIMM memory options by pressing the F9 key during POST. For more information about
UEFI System Utilities, see the Hewlett Packard Enterprise website (http://www.hpe.com/info/uefi/docs).
• iLO RESTful API for HPE iLO 5—For more information about configuring the system for NVDIMMs, see
https://hewlettpackard.github.io/ilo-rest-api-docs/ilo5/.

Removing and replacing the HPE Smart Storage Battery

Procedure
1. Power down the compute module.
2. Remove the compute module.
3. Remove the access panel.
4. Place the compute module on a flat, level work surface.
5. Unplug the battery cable from the system board.
6. Remove all DIMM baffles, and disconnect the battery from the system board.
7. Remove the HPE Smart Storage Battery.
To replace the component, reverse the removal procedure.

Removing and replacing a storage controller

Procedure
1. Power down the compute module.
2. Remove the compute module.
3. Place the compute module on a flat, level work surface.
Removing and replacing the HPE Smart Storage Battery 45