IMPORTANT:
Be sure to install the Smart Storage Battery in the same baffle from which it was removed when
replacing it.
Removing and replacing DIMMs
Procedure
1. Power down the compute module.
2. Remove the compute module.
3. Place the compute module on a flat, level work surface.
4. Remove the access panel.
5. Remove all DIMM baffles.
IMPORTANT:
Flip the DIMM baffle on top of the heatsink, and leave the Smart Storage Battery installed and on the
baffle when accessing the right DIMM baffle.
See "DIMM slot locations" to identify DIMMs installed in the compute module.
6. Remove the DIMM.
To replace the component, reverse the removal procedure. Use HPE UEFI System Utilities to configure the
memory mode.
CAUTION:
•
To prevent improper cooling and thermal damage, always install DIMMs of the same height in the
compute module.
•
This compute module does not support mixing standard and nonstandard height DIMMs.
40
Removing and replacing DIMMs