Removing And Replacing A Drive; Removing And Replacing An Sff Flash Adapter - HPE Synergy 480 Gen10 series Maintenance And Service Manual

Removing and replacing a drive

Procedure
1. Determine the status of the drive from the drive LED definitions.
2. Back up all data on the drive.
3. Remove the drive.
To replace the drive, slide the drive into the bay until it is fully seated, and then close the latch handle to lock
the drive in the bay.

Removing and replacing an SFF flash adapter

Procedure
1. Power down the compute module.
CAUTION:
Removing the SFF Flash Adapter will remove two uFF drives and might cause one or more logical
drives to fail.
2. Slide the adapter ejection handle release latch up. The handle will eject from the adapter.
3. Pull the adapter handle to remove the SFF flash adapter.
34 Removing and replacing a drive