Removing And Replacing The M.2 Ssd Adapter Board And Flash Drive - HPE Synergy 480 Gen10 series Maintenance And Service Manual

To replace the component, reverse the removal procedure.
Removing and replacing the M.2 SSD adapter board and
flash drive
Procedure
1. Power down the compute module.
2. Remove the compute module.
3. Lay the compute module on a flat and level surface.
4. Remove the access panel.
5. Remove the front panel/drive cage assembly.
6. Uninstall the front two SSD adapter board standoff screws.
7. Locate the SSD adapter board locking lever, slide and hold the locking lever backwards, and then pull
the SSD adapter board up at angle.
8. Uninstall the SSD adapter board.
9. Lay the SSD adapter board on a flat surface.
10. Remove the SSD flash drive screw, lift the drive at an angle, and then uninstall the SSD flash drive.

Removing and replacing the M.2 SSD adapter board and flash drive

35