Installation
Flush-fit installation
Create the worktop cut-out.
Remember to maintain the minimum
safety distances (see "Safety
distances").
Solid wood, tiled and glass worktops:
Fix a wooden frame 5.5 mm below
the top edge of the worktop (see
building-in diagram for "Flush-fit
installation").
Attach the sealing strip provided
underneath the edge of the cooktop.
Feed the mains connection cable
down through the cut-out.
Centre the cooktop in the cut-out.
The gap between the ceramic surface
and the worktop must be at least
2 mm wide. This is required so that
the cooktop can be sealed.
Connect the cooktop to the mains
electricity supply.
Check that the cooktop works.
Seal the gap between the cooktop
and worktop with a silicone sealant
that is heat-resistant to at least
160 °C.
Unsuitable sealant can damage
natural stone.
For natural stone worktops and
natural stone tiles, only use silicone
sealant that is specially formulated
for natural stone, and observe the
sealant manufacturer's instructions.
Please follow the manufacturer's
instructions.
80