Adjusting Hand And Day Indicator Alignment; Alignment - Casio 5502 Operation Manual

Adjusting Hand and
Day Indicator

Alignment

Strong magnetism or impact can cause the
hands and/or the day indicator to go out of
alignment. If this happens, adjust hand and
day indicator alignment.
The watch performs alignment of the hour
●
hand, minute hand, second hand, and 24-
hour hand automatically.
Adjusting Hand and Day
Indicator Alignment
1.
Pull out the crown to the second click.
2.
Hold down (D) for about five seconds, until
the second hand moves to 12 o'clock.
This will start auto alignment of the hour
hand, minute hand, second hand, and 24-
hour hand.
After auto alignment is complete, the
●
hands should be in the positions shown
below.
24-hour hand
Minute hand Hour hand
30
Second hand
3.
Press (C).
Confirm that the small hour hand and
small minute hand are stopped at 12
o'clock.
30
Small hour hand Small minute hand
4.
If the small hour hand and small minute
hand are not at 12 o'clock, rotate the
crown to align them correctly.
Operation Guide 5502
5.
Press (C).
Confirm that the disk is positioned so "0°"
is in the center.
6.
If "0°" is not positioned in the center of the
disk, rotate the crown until it is.
7.
Press (C).
Confirm that the mode hand is stopped at
12 o'clock, and check if the day is
indicated properly.
8.
If the mode hand and or the day indicator
is out of alignment, rotate the crown to
move the mode hand to 12 o'clock and the
day to the center of the indicator window.
The movement range of the mode hand
●
and day indicator is limited when you
rotate the crown. The maximum left-
right movement of the mode hand is 180
degrees in either direction. The day
indicator moves only slightly.
After the mode hand and day indicator
●
Crown
are in the positions you want, advance
to step 11 of this procedure. If you are
unable to make the adjustments you
want, go to step 9.
9.
Press (C).
Confirm that the day indicator shows 1.
Changing the date setting will cause the
●
mode hand to rotate repeatedly. In
some cases, the mode dial may
continue to rotate for about 5 minutes.
Hand and Day Indicator Movement
l
30
Disk
Mode hand
30
Day (Operation start day)
1
Day
10.
If 1 is not shown for the day, rotate the
crown until 1 is shown for the day.
The mode hand moves in conjunction
●
with crown rotation. Move the mode
hand to 12 o'clock.
11.
Push the crown back in.
Note
Leaving the crown pulled out for
●
more than approximately 30 minutes
without performing any operation
will automatically cause the
adjustment operation to become
disabled. If this happens, push the
crown back in to its normal position
and then pull it out again to restart
the procedure from the beginning.
Pushing the crown in to its normal
position part way through the
alignment procedure will cause the
hands to return to their normal
position. Any alignment you
performed up to that point will be
applied.
19