Preparation For Using The Network Twain Scanner - Ricoh Aficio 106/LD215c Function Manual

Preparation for Using the Network TWAIN Scanner

This section explains the preparation and settings for using the network TWAIN
scanner function.
Important
❒ To use the network TWAIN scanner, a TWAIN-compliant application, such
as DeskTopBinder, must be installed on the client computer. DeskTopBinder
Lite is on the supplied CD-ROM. For details about installing DeskTopBinder
Lite, see "Installing DeskTopBinder Lite from Provided CD-ROM".
A
Connect the machine to the network.
Connect the machine to the network using an Ethernet cable or IEEE 1394 ca-
ble, or wireless LAN (IEEE 802.11b).
B
Make the necessary network settings in [System Settings].
If you have connected the machine to the network using an Ethernet cable,
make the following settings. For details, see General Settings Guide.
• Specify the machine's IPv4 address and subnet mask.
• In [Effective Protocol], enable [IPv4].
C
Install the TWAIN driver on a client computer.
For details about installing the TWAIN driver, see "Installing the TWAIN
Driver from Provided CD-ROM".
Note
❒ To connect the machine to the network using an IEEE 1394 cable or using
wireless LAN (IEEE 802.11b), an extended 1394 board or extended wireless
LAN board is required respectively. For details, see Network Guide.
❒ Items to set up in [System Settings] vary depending on the network environ-
ment. For more information about network settings, see General Settings
Guide.
❒ For more information about [System Settings], see General Settings Guide.
Reference
p.90 "Installing TWAIN Driver from Provided CD-ROM"
p.73 "Installing DeskTopBinder Lite from Provided CD-ROM"
When Using as a TWAIN Scanner
4
89