JUKI HZL-NX7 Instruction Manual page 109

❹
❽
● Buttonhole clamping plate

❼
❾
6
Unplug the sensor pin ❹ after sewing.
7
Opening the buttonhole using a ripper ❼ .
[Double bartack]
Pierce a stopper pin ❽ at the bartack and open the
buttonhole with a ripper ❼ . Be careful not to cut the
stitches.
[Keyhole buttonhole]
Place a cardboard under the buttonhole and make a
hole with the eyelet punch ❾ . Then pierce a stopper
pin at the bartack and open the buttonhole with a rip-
per.
Leave the machine in Lock mode
It will be easier to sew buttonholes on the thin fabrics
and/or near the overlapped sections, if the clamping
plate is used.
1. Attach the buttonhole presser foot
B
to the presser foot holder, with the
clamping plate  together.
2. Place the fabric between the presser
foot and the clamping plate.
* You can remove the clamping plate by holding B.
107