JUKI HZL-NX7 Instruction Manual page 107

❸
A
B
* Check the following
points after setting the
presser foot and then
start to sew buttonholes.
❹
1
❶
❷
2
Check that
there is a
clearance.
3
Set the presser foot.
Lift the needle and lift the presser foot.
Align the groove ❶ of the presser foot holder with the
❷ of the presser foot and lower the presser foot hold-
er to set.
Set the button.
Pull the button holder ❸ toward A, place the button
on the button holder, and then push the holder toward
B to set the buttonhole length.
Set the buttonhole sensor pin ❹ .
Insert the sensor pin into the sensor pin hole at the
face plate cover.
* Insert the pin into the hole completely.
* If the machine starts to sew without inserting
the pin into the hole, the following message
will be shown on the display.
If there is not a
clearance, the
machine will not
sew neat stitches.
Set the sensor pin and
restart.
105