Procedure To Operate Without Installing The Configuration Tool - Mitsubishi Electric RD81DL96 User Manual

Procedure to operate without installing the configuration tool

This section shows the procedure for using the high speed data logger module without installing the configuration tool.
For the setting method using the configuration tool, refer to the following manual.
MELSEC iQ-R High Speed Data Logger Module User's Manual(Application)
High speed data logger module
Insert the SD memory card.
*1 Perform a self-diagnostics test as necessary. (MELSEC iQ-R High Speed Data Logger Module User's Manual(Application))
*2 Do not use an electric screwdriver to attach and remove module fixing screws.
*3 Page 68 System configuration for the initial setup, maintenance, and inspection
Page 51 Network settings for connection
*4 Page 62 SD Memory Card
*5 Page 53 Configure the web browser
*6 Page 53 Online startup
4 PROCEDURES PRIOR TO OPERATION
50
4.1 Start up of High Speed Data Logger Module
*1
Mount to base
*2
Connect the high speed data logger module and configuration personal computer on a 1:1 basis.
Turn ON the system
(RUN LED turns ON)
*4
Write the settings to the high speed data logger module.
Connect the configuration personal computer and the high speed data logger module
Set the Data logging setting, Event logging setting,
according to the "Network Setting"
Start operation
Configuration personal computer
*3
Configure the web browser
Connect to the high speed data logger module
with the web browser.
Start the Configuration Tool online
Select "Connection via hub"
from the "Transfer setup" screen
Format the SD Memory card.
Configure common settings.
and Report setting
*5
*6