Table of Contents
Advertisement
5.2.1
Selecting the calibration curve
5.2.2
Start the measurement
5.2.3
Interrupt and resume the measurement
5.2.4
Stop measurement
5.3
Show the data in the display
5.4
Delete data for a calibration curve
Before starting the measurement, the calibration curve that corresponds to the
measurement point must be selected.
1. Select
, confirm with
MENU
2. Select
, confirm with
CALIBRATE
3. Selectthe curve shown and confirm with
4. Select the desired curve with the navigation key
.
ENTER/ON
5. Select
twice to return to the main menu.
CLEAR/OFF
When starting the measurement, the measurement is carried out continuously and the
current measurement value is saved at intervals.
1. Select
, confirm with
MEASURE
2. Select
and confirm with
START
1. Press
for 2 seconds.
CLEAR/OFF
The instrument is switched off and the measurement is interrupted.
2. Press
for 2 seconds.
ENTER/ON
The instrument switches on and the measurement continues with the same settings
as before the instrument was switched off.
1. Select
, confirm with
MEASURE
2. Select
, confirm with
STOP
The display shows the stored data for the corresponding calibration curves.
1. Select the desired calibration curve (refer to
2. Select
, confirm with
DATA
3. Select
DISPLAY DATA
Only the stored data for the selected calibration curve is displayed.
1. Select the desired calibration curve (refer to
2. Select
, confirm with
DATA
3. Select
DELETE MEP
Only the stored data for the selected calibration curve is deleted.
4. Select
, confirm with
YES
Note: NO aborts the erasing procedure.
.
ENTER/ON
.
ENTER/ON
ENTER/ON
.
ENTER/ON
.
ENTER/ON
.
ENTER/ON
.
ENTER/ON
.
ENTER/ON
and confirm with
ENTER/ON
.
ENTER/ON
and confirm with
ENTER/ON
.
ENTER/ON
.
and confirm with
UP/DOWN
section 5.2.1, page
27).
.
section 5.2.1, page
27).
.
Operation
27
Hide quick links:
Advertisement
Table of Contents
