Installation
Figure 5
Connecting the probe plug to the instrument
1
Probe plug
3.4
Switching the instrument on and off
3.4.1
Register a new probe
14
1. Fully charge the rechargeable batteries (see
Note: The rechargeable batteries are fully charged when the LED on the charger is green.
2. Press
for two seconds to turn on the instrument.
ENTER/ON
Note: If the instrument does not turn on, check the position of the rechargeable batteries.
3. Press
for two seconds to turn the instrument off again.
CLEAR/OFF
If a new probe is connected during initial installation, the error message "Incorrect probe"
is displayed.
1. Select
and confirm with
MENU
2. Select
and confirm with
SYSTEM
3. Enter code
using the navigation keys (see
390
.
ENTER/ON
4. Select
twice to return to the main menu.
CLEAR/OFF
Note: The probe is now registered and the TS curves can be calibrated (see
page
23).
2
Probe connection
section
3.2.3).
.
ENTER/ON
.
ENTER/ON
section 4.2, page
15) and confirm with
section 5.1,